Tuner; Listening To The Radio - Sony SHAKE-100D Operating Instructions Manual

Tuner

Listening to the radio

1
Press FUNCTION repeatedly to
select FM or AM band.
2
For automatic scanning:
Hold down TUNING+/– until the
frequency indication changes and then
release.
Scanning stops automatically when a
station is tuned in. "TUNED" and
"ST" (for FM stereo programs only)
light up in the display panel.
If "TUNED" does not light up and
scanning does not stop, press x to stop
scanning. Then, perform manual
tuning (below).
For manual tuning:
Press TUNING+/– repeatedly to tune
to the station you want.
Note
When you tune to an FM station that provides
RDS services, information such as the service
name or station name is provided by broadcasts.
You can check the RDS information by pressing
DISPLAY repeatedly.
Tip
To reduce static noise on a weak FM stereo
station, hold down SHIFT, then press FM
MODE repeatedly until "MONO" lights up in
the display panel.
To change the AM tuning interval
(Except for Russian models)
The default setting for AM tuning interval
is 9 kHz (or 10 kHz for some areas). You
cannot change the AM tuning interval in
Power Saving Mode.
Use the buttons on the unit to perform this
operation.
38 GB
1
Press TUNER/BAND repeatedly to
select AM band.
2
Press "/1 to turn off the system.
3
While holding down TUNER/BAND,
press "/1.
"AM 9K STEP" or "AM 10K STEP"
appears in the display panel.
When you change the interval, all the
AM preset stations are erased.
Presetting radio stations
You can store up to 20 FM and 10 AM
stations as your favorite stations.
1
Tune to the station you want.
2
Press DVD/TUNER MENU.
3
Press / repeatedly to select
the preset number you want,
then press
"COMPLETE" appears in the display
panel. The station is stored.
To tune to a preset station
Press PRESET+/– repeatedly to select the
preset number you want.
You can also press the numeric buttons,
then press to select a preset station.
Preset number
.