2.5
LED Status Indicators
The LED status indicators are located on the right side of the projector. Each
LED is defined below.
•
LIGHT LED
LED Status
Red (flashing)
Orange (solid)
Green (solid)
Off
•
STATUS LED
LED Status
Off
Off, but keypad LED
is on
Green (solid)
Green (flashing)
Orange (solid)
Orange (flashing)
Green (flashing) /
Red (flashing)
Red (solid)
Red (flashing)
GS Series User Manual
020-000724-01 Rev. 1 (05-2014)
When projector has lost over 60% initial luminance
Laser diode time has expired
Laser diode is on and operating correctly
Laser diode is off
AC power is off (without AC plug in)
AC has been applied, projector is in standby mode
Projector is powered up and operating normally
Projector communications
Non-portrait mode used
NOTE: Please refer to section 3.5.
Projector is in cool down mode or startup mode
Projector is in flash (LAN) update state
Over-temperature
Fan failure
Section 2: INTRODUCTION
Projector State
Projector State
2-8