Audio Setup Options - CyberHome CH-DVD 300 Owner's Manual

Audio Setup Options

Adjusting Audio Settings in the Audio Setup Page
The settings you choose in the Audio Setup Page will be determined by the
type of audio equipment you are using with the DVD Player. The factory
default settings are configured with the assumption that you are using the
player with a standard Television supporting Stereo Audio Inputs. This
menu will allow you to enable the Digital Audio Output if you wish to use the
Coaxial Digital Audio Output with a Digital Receiver.
DIGITAL OUTPUT
SPDIF (Sony/Philips Digital InterFace) refers to the digital audio format
used by most consumer electronics equipment, as well as the Coaxial
Digital Audio Output connector. If you are using the Stereo Audio Outputs,
leave set to OFF. If you wish to use the Coaxial Digital Output, change this
setting to BITSTREAM or LPCM. 48K Generally, the BITSTREAM setting is
used with receivers capable of Dolby Digital 5.1 or DTS 5.1 channel
decoding, while the LPCM 48K setting is reserved for two channel
30
DVD
AUDIO
DIGITAL OUTPUT BITSTREAM