Table of Contents
Advertisement
Administration
Rebooting the Switch
Rebooting the Switch
STEP 1
STEP 2
STEP 3
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
A progress bar appears while the file is downloading.
The file selected by administrator is downloaded to RAM and is validated for
following conditions:
•
The CRC of the file is good.
•
The STK file is built for this platform.
•
The STK file size is within the partition limits (4.5 MB is reserved for this file).
If these conditions are met, the file is written to Flash memory and the system is
rebooted using the new firmware.
If any of these checks fail, the image is not written to Flash memory and the
recovery process is stopped. You can restart the recovery process with a correct
image file.
If the transfer is aborted because the browser window is refreshed or closed, the
session is cleared and the session times out immediately. If the transfer is aborted
because the network is unreachable, the session times out after 45 seconds. After
the session times out, you can begin the recovery process again.
Use the Reboot page reboot the switch. To reboot the switch:
Click Administration > Reboot in the navigation window.
Select one of the following options:
•
Reboot—Reboots the switch using the latest save configuration.
•
Reboot to Factory Default—Reboots the switch using with the factory
default configuration file. Any customized settings are lost.
A window appears to enable you to confirm or cancel the reboot. The current
management session might be terminated.
Confirm or cancel the reboot.
4
65
Advertisement
Table of Contents
