Downloading And Backing Up The Configuration And Log Files; Downloading A Configuration File To Restore Settings - Cisco SG200 Series Administration Manual

Administration
File Management
WARNING
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SG200 Series 8-port Smart Switches Administration Guide
Ensure that power to the switch remains uninterrupted while downloading an image
or a boot code file to the switch. If a power failure occurs while downloading a file,
the file contents in persistent memory are lost.
If a power outage occurs during boot code file download, the switch will not be
able to boot. Contact the Cisco Small Business Support Center for assistance.
If a power outage occurs during image download, the image will not load, but the
boot loader will continue to be operational. See
for instructions on downloading a working image.

Downloading and Backing Up the Configuration and Log Files

You can use the Download/Backup Configuration/Log page to download a saved
configuration file to the switch to restore previously saved settings, or back up the
current configuration file to a network location. You also can use these pages to
back up log files.
•

Downloading a Configuration File to Restore Settings

• Backing Up the Configuration File and Logs
Downloading a Configuration File to Restore Settings
To download a configuration file to the switch to restore a previously backed-up
file:
Click Administration > File Management > Download/Backup Configuration/
Log in the navigation window.
Select the Transfer Method (HTTP or TFTP).
For the Save Action, select Upgrade to download the file that you will specify
below.
Enter the following parameters:
• TFTP Server (TFTP only)—Specify the IPv4 or IPv6 address of the TFTP
server. Or specify the server name if DNS is enabled in the IP configuration
(see Domain Name System).
Firmware Recovery Over HTTP
4
54