12
SERVICE WORK ON THE CHASSIS
12.30
Removing the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
12.31
Installing the main silencer
12.32
Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever on angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
309345-11
Finishing work
–
Install the main silencer. (
–
Install the right side cover. (
–
Mount the seat. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Remove the right side cover. (
Main work
–
Disconnect spring
–
Remove screws
B01814-11
Main work
–
Mount the main silencer. Mount screws
–
Reconnect spring
–
Tighten screws
Guideline
Remaining screws, chassis
B01814-10
Finishing work
–
Install the right side cover. (
.
4
.
5
M10
p. 54)
p. 56)
p. 49)
p. 55)
.
1
and take off the main silencer.
2
1
.
2
.
1
p. 56)
x
M14x1.5
80 Nm (59 lbf ft)
60 Nm
Loctite
(44.3 lbf ft)
p. 41)
but do not tighten yet.
M6
10 Nm (7.4 lbf ft)
54
®
2701™