Removing The Rear Wheel - Husqvarna FE 350 EU Owner's Manual

14 WHEELS, TIRES
14.3

Removing the rear wheel

–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
The brake linings are positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact with
the brake disc.
–
Remove the motorcycle from the lift stand. (
L00212-11
–
Pull the front wheel brake and push down hard on the fork several times to align the
fork legs.
–
Tighten screws
Guideline
Screw, fork stub
x
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Press the brake caliper by hand on to the brake disc in order to press back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
Info
Protect the motorcycle and its attachments against damage by covering
them.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swingarm.
B01790-10
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not damaged.
–
Remove spacers
101848-10
.
2
.
3
.
1
. Withdraw wheel spindle
2
.
4
M24x1.5 45 Nm (33.2 lbf ft)
p. 41)
M8 15 Nm (11.1 lbf ft)
p. 41)
only enough to allow the rear
3
75