Installing The Lower Triple Clamp - Husqvarna FE 350 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12

Installing the lower triple clamp

–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
C00567-11
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Mount protective ring
B01632-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line next to the voltage regulator.
C00585-10
–
Position the fork legs.
Info
The compression damping is located in the left fork leg COMP (white adjust-
ing screw). The rebound damping is located in the right fork leg REB (red
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
Position bleeder screws
C00598-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
C00586-10
. Remove protective ring
4
p. 110)
and O-ring .
2 3
but do not tighten yet.
4
toward the front.
5
.
6
.
5
is correctly positioned.
1
M8 15 Nm (11.1 lbf ft)
45