Changing The Engine Oil And Oil Filter, Cleaning The Oil Screen - Husqvarna FE 350 EU Owner's Manual

Husqvarna fe 350 motorcycles 2014 owner's manual
Table of Contents

Advertisement

18
SERVICE WORK ON THE ENGINE
18.3

Changing the engine oil and oil filter, cleaning the oil screen

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the engine oil only when the engine is warm.
The engine oil is at a level between the lower edge
of the level viewer.
»
If the engine oil is not up to the lower edge
Preparatory work
Park the motorcycle on a level surface.
Remove the engine guard. (
Main work
Place a suitable container under the engine.
Remove oil drain plug
Info
Do not remove screws
B01769-10
Remove plug
Completely drain the engine oil.
Thoroughly clean the parts and sealing surfaces.
B01770-10
Position oil screen
Insert the pin wrench through the drill hole of the screw plug and into the engine
case on the opposite side.
Push the oil screen all the way into the engine case.
B01771-10
Add engine oil. (
p. 94)
p. 64)
with the magnet and seal ring.
1
on both sides.
A
with oil screen
and the O-rings.
2
3
with the O-rings on a pin wrench.
3
and the upper edge
A
of the level viewer:
A
x
92
C

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fe 350 ausFe 350 usaFe 2502014 fe 350

Table of Contents