Lighting Instructions; Operating Instructions - Thermal Solutions EVCA SERIES Installation, Operating And Service Instructions

V. Lighting Instructions
FOR YOUR SAFETY, READ BEFORE OPERATING
WARNING:
A
. This appliance is equipped with an ignition device
which automatically lights the pilot. Do NOT try to
light the pilot by hand.
B
. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1. STOP! Read all the safety information (warnings,
cautions etc.) in this manual.
2. Turn off all electric power to the appliance.
3. Set the system control so that there is no call for heat
to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the pilot and main
burner. Do not try to light the pilot or main flame
by hand.
5. Remove front door panel.
6. Locate the gas pilot valve at the rear of the appliance.
7. Locate the gas main valves at the rear of the
appliance and at the end of the gas supply pipe inside
the appliance.
8. Rotate gas shutoff valves clockwise
"ON" position to "OFF". Make sure handle rests
against stop.
9. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the safety information above on
this label. If you do not smell gas, go to the next step.
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury, or loss of life.

OPERATING INSTRUCTIONS

from
• If you cannot reach your gas supplier, call the fire
department.
C
. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
10. Rotate gas shutoff valves counterclockwise
from "OFF" to "ON". Make sure handle rests against
stop. Do not force.
12. Turn on all electric power to the appliance.
13. Set thermostat to desired setting.
14. If the appliance will not operate, follow
the instructions " TO TURN OFF GAS TO
APPLIANCE" and call your service technician or
gas supplier.
15. Move the switch to the "ON" position.
16. Set system control so that there is a call for heat
from the system.
17. Observe prepurge, pilot ignition and main flame
ignition.
18. If pilot or main flame ignition does not occur
during initial attempt, remove the upper front jacket
panel of the appliance. If the appliance pilot and
main flame light, go to step 20.
44