Wall Sleeve And Outdoor Grille; Installation - Sea Breeze PTAC Installation And Operation Manual

•
When installing the outdoor grille, the mounting screws should be tightened from
the inside of the Wall Sleeve. If replacing an old chassis with an existing grille or
using a specialized grill in a new installation, contact your dealer to determine if
the new chassis should be used with the nonstandard specialized grille.

3. Installation

•
Front cover removal
Remove the front cover by pulling out at the bottom to release it, then lift it up to
clear the rail along the chassis top.
•
Chassis Installation
Slide the chassis into the wall sleeve until the chassis flanges contact the front
edge of the wall sleeve, and then secure with four screws through the chassis
flange holes.
•
Connect the Wall Mounted Controller (if used).
Firmly connect the electrical connector of the wall mounted controller to the
electrical connector of the unit. (Located near the right bottom of the chassis)
•
Front Cover Installation
Reinstall the front cover by hooking the top over the rail along the chassis top,
then pushing it in at the bottom.
950-0094revF - 6 - November 26, 2008