Installing The Switch; Included Parts - HP ProCurve 2910al Series Installation And Getting Started Manual

Installing the Switch

The HP ProCurve 2910al Switches come with an accessory kit that includes
the brackets for mounting the switch in a standard 19-inch telco rack, in an
equipment cabinet, and with rubber feet that can be attached so the switch
can be securely located on a horizontal surface. The brackets are designed to
allow mounting the switch in a variety of locations and orientations. For other
mounting options contact your local ProCurve authorized network reseller or
ProCurve representative. This chapter shows how to install the switch.
C a u t i o n
If the switch is to be shipped in a rack, be sure to use only an HP 10K rack.
Mount the switch using rail kit, ProCurve 1U RK MT SWITCH 10K ALL, part
number 356578-B21 and shelf kit AB469A, HP rx 16/26 Factory Rackmount
Shelf Kit. Both kits must be used. Otherwise you will void the warranty.

Included Parts

The 2910al Switches have the following components shipped with them:
■
■
■
■
■
■
HP ProCurve Switch Quick Setup sheet
HP ProCurve Switches General Safety and Regulatory Information
booklet
2910al Switch Specific Safety and Regulatory Information sheet
Read Me First
Customer Support/Warranty booklet
Console cable (5188-3836)
2
2-1