Casio XJ-UT310WN User Manual page 57

Use this menu item:
Image Adjustment 2 3
Overscan (CVD)
Image Adjustment 2 3
Restore Menu Defaults
(RCVD)
Volume Adjustment 3
Volume
Volume Adjustment 3
Restore Menu Defaults
Screen Settings 3
Keystone Correction
Screen Settings 3
Aspect Ratio (RCVHD)
Screen Settings 3
Projection Mode
Screen Settings 3
Ceiling Mount
Screen Settings 3
Startup Screen
Screen Settings 3
No Signal Screen
Screen Settings 3
Blank Screen
Screen Settings 3
Digital Screen Shift
Screen Settings 3
Restore Menu Defaults
To do this:
Adjust the overscan amount for an input video signal within the range of 0% to 5%*.
The size of the border area displayed on the projection screen depends on the
setting value. A smaller value results in a wider border area as shown below.
Return all of the items in the "Image Adjustment 2" main menu to their initial defaults
for the currently projecting image source.
See "To adjust the volume level (VOLUME)" (page 47) for more information.
Return the Volume setting to its initial default for the currently projecting image
source.
Use this sub-menu to perform vertical keystone correction of the projected image.
Select an aspect ratio setting for the projected image.
See "To change the aspect ratio of the projected image (ASPECT)" (page 49) for
more information.
Specify whether projection will be from the front of the screen or the back of the
screen.
Front*: Select this option to project from the front of the screen.
Rear: Select this option to project from the back of the screen. This setting flips the
front projected image horizontally.
Set up the projector to be hung from a ceiling.
On: Select when the projector is hung from a ceiling. Since the bottom of the
projector is upwards, the projected image is flipped both horizontally and
vertically.
Off*: Select when the projector is used on a desktop. This projects the image
assuming that the top of the projector is upwards.
Specify whether or not a startup screen should be projected whenever projector
power is turned on, and select the image to be used as the startup screen.
Logo: Projects a logo built into the projector or a user logo (page 75) as the startup
screen.
None*: Disables startup screen projection.
Select one of the following as the projection image whenever there is no input signal
being input to the projector: "Blue"* (blue screen), "Black" (black screen), "Logo"
(projector built-in logo, or user logo, page 75).
Select one of the following as the projection image whenever the [BLANK] key is
pressed: "Blue"* (blue screen), "Black" (black screen), "Logo" (projector built-in
logo, or user logo, page 75).
See "Digital Screen Shift" (page 61).
Return all of the items in the "Screen Settings" main menu to their initial defaults for
the currently projecting image source.
Display range at 5%
Display range at 0%
57