Using Ez-Converter Fa To Convert Powerpoint Files To Eca Or Ptg Files - Casio XJ-UT310WN User Manual

Using EZ-Converter FA to Convert PowerPoint Files to ECA or
PtG Files
EZ-Converter FA is computer software for converting PowerPoint files to ECA files or PtG files, which
can be played back using the projector's File Viewer. EZ-Converter FA supports conversion of files
created with Microsoft Office PowerPoint 2003, 2007 and 2010.
Important!
Before trying to use EZ-Converter FA, be sure to go to the CASIO website
(http://www.casio-intl.com/support/) and check the information there about minimum
computer system requirements, and conditions governing download and use.
The procedure below assumes that you already have EZ-Converter FA installed on your
computer.
Note
Save for certain exceptions (described below), playback and projection of an ECA file or PtG
file normally should be able to reproduce transitions, animations, and other special effects of
the original PowerPoint file.
• Conversion of OLE objects (movies, audio, etc.) and VBA objects in a PowerPoint file is not
supported.
• Conversion of timer and repeat operations in a PowerPoint file animation is not supported.
• An animation in a PowerPoint file is converted up to the time specified by "To specify the
maximum animation display time" (page 39), and everything after that is cut. When the point
up to which the animation was converted is reached during playback of the converted file,
playback will pause, and you will have to press the [ENTER] key to advance to the next step.
• The source PowerPoint file plays when you convert a file with EZ-Converter FA. If there is no
change on the screen for about three consecutive seconds during this playback, say
between Points A and B, for example, the effect at Point B in the original file is ignored and
not converted. When Point B is reached during playback of the converted file, playback will
pause, and you will have to press the [ENTER] key to advance to the next step.
Starting a conversion operation with EZ-Converter FA will temporarily change the screen
settings of your computer as shown below. Screen settings will revert back to what they were
after the conversion operation is complete.
Operating System:
Windows XP
Windows Vista or
Windows 7
Windows 8
The screen resolution of the ECA file or PtG file will be the resolution specified by the
EZ-Converter FA setting (800 × 600, 1024 × 768, 1280 × 768 or 1280 × 800) when the file
conversion operation starts. For information about configuring this setting, see "To specify the
screen resolution of the ECA file or PtG file" (page 39).
Changes:
Screen resolution changes to 800 × 600, 1024 × 768, 1280 × 768 or
1280 × 800.
Display card hardware acceleration is disabled.
Screen resolution changes to 800 × 600, 1024 × 768, 1280 × 768 or
1280 × 800.
Windows changes to the Basic mode (Windows Aero
Screen resolution changes to 800 × 600, 1024 × 768, 1280 × 768 or
1280 × 800.
36
TM disabled).