Viewing The Data From The Last Calibration; Viewing Stored Readings (The Data Log) - Thermo Scientific Orion Star A111 Reference Manual

Viewing the Data from the Last Calibration

1. In measurement mode, press
2. Press
a. To view the slope, press
b. To view the calibration points press
3. Press

Viewing Stored Readings (the Data Log)

1. In measurement mode, press
2. Press
3. Press
16
.
until "6.0" is shown on the top, secondary display and "CAL" is shown on the larger, primary display.
be on the larger, primary display. If a 3-point calibration was done, press
segment (SLP.2), and again to display the average slope (SLP.A).
shown at the top of the display. The corresponding buffer value will be shown in the lower, primary
display.
Note: It will only show the values used. For example, if there was only one calibrated value, BUF2 and
BUF3 will not show.
to exit the setup menu and return to measurement mode.
.
or to scroll through the memory points.
to review the reading stored at that point.
Thermo Scientific Orion Star A111 Benchtop and Star A121 Portable pH Meters
. SLP.1 will be on the top, secondary display. The slope percentage will
and then, press
to view the second slope
or until BUF1, BUF2 or BUF3 is