Char-Broil 463234703 Assembly, And Care Manual page 12

Professional series
Table of Contents

Advertisement

CA
CA UTION
CA
CA
CA
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety
reasons.
• Do not use water on a grease fire. Personal injury
may result. If a grease fire develops turn knobs and
gas source off.
• Do not leave grill unattended while preheating or
burning off on high. If grill has not been regularly
cleaned a grease fire can occur that may damage the
product.
Ignitor Lighting
Do not lean over grill while lighting. 
1. Open  lid  during  lighting 
2. To ignite any burner, turn knob to HI, push and hold 
ELECTRONIC IGNITOR button for 5 seconds. 
3. If ignition does not take place within 5 seconds, turn all 
burner knobs to OFF, wait 5 minutes, then repeat lighting 
procedure. 
4. If IGNITOR does not work, follow match lighting 
instructions.
Match Lighting
Do not lean over grill while lighting. 
1. Open lid during  lighting. 
2. Place  lit match  into match 
lighting stick, then into lighting 
hole on right side of grill. 
3. Push in and turn far right burner 
knob to HI. Be sure burner lights 
and stays lit. 
4. Light adjacent burners  in 
sequence by pushing knobs in and turning to HI.
WARNING
WARNING
WARNING
WARNING
WARNING
• If burner does not light turn knobs to OFF, wait 5
minutes, try again.
Rotisserie Ignitor Lighting
Do not lean over grill while lighting. 
1. Open  lid  during  lighting 
2. To ignite rotisserie burner, turn knob to high,push and hold 
Electronic Ignitor button for 5 seconds.If burner does not 
light,turn burner knob to off,wait 5 minutes,then repeat 
lighting  procedure. 
3. If IGNITOR does not work, follow match lighting 
instructions. 
12 • 463234703
UTION 
UTION
UTION
UTION
Match Lighting
Do not lean over grill while lighting. 
1. Open lid during  lighting. 
2. Place lit match near rotisserie spark electrode wire. 
3. Push in and turn rotisserie knob to ON. Be sure burner 
lights and stays lit. 
Sideburner Ignitor Lighting
Do not lean over grill while lighting. 
1. To ignite SIDEBURNER, open sideburner cover. 
2. To ignite side burner, turn knob to HI, push and hold 
ELECTRONIC IGNITOR  button for 5 seconds. 
3. If sideburner does NOT light, turn knob to OFF, wait 5 
minutes,  then repeat lighting procedure. 
4. If IGNITOR does not work, follow match lighting 
instructions. 
Match Lighting 
1. To match light SIDEBURNER, open 
sideburner  cover. 
2. Place lit match near burner. 
3. Push in and turn sideburner 
knob  counter­clockwise.  Be 
sure burner lights and stays lit.
Burner Flame Check 
• Remove grates and flametamers. Light burners, rotate knobs 
from HI to LOW. You should see a smaller flame in LOW 
position than seen on HI. Always check flame prior to each 
use. If only low flame is seen refer to "Sudden drop or low 
flame" in the Troubleshooting Section. 
Turning Grill Off 
• Turn all knobs to OFF position. Turn gas OFF at gas source. 
Ignitor Check
• Turn gas off at gas source. Push and hold electronic 
ignitor button. "Clicks" should be heard and spark seen each 
time between collector box or burner and electrode. See 
"Troubleshooting" if no click or spark. 
Valve Check
• Important: Make sure gas is OFF at gas source before
checking valves.   Knobs  lock  in OFF  position. To check 
valves, first push in knobs and release, knobs should spring 
back. If knobs don't spring back, replace valve assembly 
before using grill. Turn knobs to LOW position then turn back 
to OFF position. Valves should turn smoothly. 
H I

Advertisement

Table of Contents
loading

Table of Contents