Canon imageRunner Advance 4051 Basic Operation Manual page 67

3
3
Load the paper stack into the paper deck unit .
When closing the paper deck unit, be careful not to get your fingers caught, as this may result in
personal injury .
• Paper which is curled must be straightened out before loading it into the paper deck unit.
• You will not be able to make copies or print if you load paper that exceeds the loading limit mark (
drawer is not completely pushed into the paper deck unit.
• Make sure that the height of the paper stack does not exceed the loading limit mark (
• Always check that the paper deck unit is closed.
• The paper deck unit holds up to 2,700 sheets of paper (21 lb bond (80 g/m
• Load the paper stack in stages, adding approximately 500 sheets of paper at a time. If the paper deck unit can
accommodate more paper, the lifter will descend.
• Only load LTR paper into the paper deck unit. Paper cannot be loaded horizontally.
• If there are instructions on the paper package about which side of the paper to load, follow those instructions.
• When the paper is loaded into the paper deck unit, the side facing down is the one printed on.
• If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reloading it.
• For more information on the print direction of preprinted paper (paper which has logos or patterns already printed on it),
see e-Manual > Copy.
• Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
• If paper runs out and printing is stopped, load a new paper stack. Printing restarts after the new paper stack is loaded.
1.■ Load■the■paper■stack■against■
the■back■left■guide■of■the■
paper■deck■unit.
2.■ Close■the■paper■deck■unit.
When■the■paper■deck■unit■
is■closed,■the■inside■lifter■
automatically■ascends,■and■the■
machine■becomes■ready■for■
printing.
), or if the paper
).
)).
2
67