Jumper Settings; Jumper On Pk8041 Board; Jumper On Pk8042 Board; Pixel Clock Output - JAI CV-M300 Operation Manual

Industrial monochrome ccd camera

Hide thumbs Also See for CV-M300:

Table of Contents

7.3. Jumper Settings

Cautions on Jumper Setting.

Before making any mode or jumper setting turn the power OFF.

Jumpers for mode setting are found on the boards PK8041 & PK8042.

The following modes are available with jumper setting:

Input/Output Mode of HD/VD signal. (HD/VD input is factory setting)

Edge Pre-select Mode. (Factory setting)

Pulse Width Control Mode

Start/Stop Trigger Mode

Long Time Exposure Mode

Set the jumpers according to the list below in 7.3.1. and 7.3.2.

The jumper positions are shown in "7.4.1. Board 8041 Side A" and "7.4.2. Board 8042 Side A".

Switch SW2 on PK8041 is shown in "7.2. SW2 on PK8041 Board".

*) Factory Setting

*) Factory Setting

To use pixel clock output (TTL level: 4.0 V), make the jumper JP13 on PK8041 board shorted-circuited. The

jumper position is shown in "7.4.1. Board PK8041 Side A".

Pixel clock pulse will be output from pin no.9 of 12-pin multi-connector.

Cautions for Pixel Clock Output.

When the pixel clock is enabled, it may cause interference with external equipment if it not properly

shielded.

CV-M300

- 16 -

Table of Contents