9-7-2. Error Clearing Function
1. Clearing from the main remote controller
[Error clearing in outdoor unit]
Error of the outdoor unit is cleared by the unit of one refrigerant circuit system to which the indoor units oper-
ated by the remote controller. (Error of the indoor unit is not cleared.)
For clearing errors, the service monitor function of the remote controller is used.
<Method>
1
Change the mode to service monitor mode by pushing
seconds or more.
2
Using
/
buttons, set "FF" to item code.
The display in Section A in the following figure is counted with interval of 5 seconds as
#
"
" → → → → → "
" → → → → → "
"
When the count arrives "
∗ However, counting from "
3
TEST
When
button is pushed, the status returns to the normal status.
Operation procedure
®
®
1
2
3
The status returns to the normal status.
Section A
[Error clearing in indoor unit]
Error in the indoor unit is cleared by
(Only error of the indoor unit connected with operating remote controller is cleared.)
!
" → → → → → "
" → → → → → "
", the error is cleared.
#
" is repeated on the display.
TEMP.
3
FILTER
RESET TEST
1
ON / OFF
button on the remote controller.
CL
TEST
+
" → → → → → "
".
CODE No.
UNIT No.
R.C.
No.
ON / OFF
TIMER SET
FAN
MODE
TIME
SWING/FIX
VENT
SET CL
UNIT
99
buttons simultaneously for 4
2