Control Outline - Toshiba MiNi-SMMS MCY-MAP0501HT Service Manual

6. CONTROL OUTLINE

6-1. Indoor Unit
6-1-1. Control Specifications
No. Item
1 Power supply (1) Identification of outdoor unit
is reset.
(2) Check code clear
2 Operation (1) Based upon the operation command received from the
select
3 Room temp. (1) Set point temperature adjustment range on remote controller
control
(2) The set point temperature in heating operation can be offset
4 Automatic (1) The difference between the temperature reading taken from
capacity
control
5 Air volume (1) The remote controller is used to select the modes "HIGH
control
(2) The difference between the temperature reading taken from
Outline of specifications
When the power supply is reset, the outdoor units are
individually identified and communication is established.
When the power supply is reset, the check code is also reset.
If an abnormal status is still present upon restart the check
code will be displayed again on the remote controller.
remote controller or central controller, the operation mode is
selected.
Remote controller
command
STOP
FAN
COOL
DRY
HEAT
(°C)
All cooling
Wired type 18 to 29°C
Wireless type 18 to 30°C
using item code (DN) 06.
Setup data
Setup temp. correction
Setup at shipment
Setup data 2
the Ta (room) sensor and the Ts (set point) selected on the
remote controller is used to determine the demand frequency
to the outdoor unit.
(HH)", "MED (M)", "LOW (L)" or "AUTO".
the Ta (room) sensor and the Ts (set point) selected is used
to control the air volume setting when in "AUTO" mode.
Control outline
Stops air conditioner.
Fan only operation
Cooling operation
∗
Dry operation
Heating operation
All heating
18 to 29°C
16 to 30°C
0 2 4
+0°C +2°C +4°C
55
Remarks
∗ Concealed Duct High
Static Pressure type air
conditioner cannot operate
in drying mode.
6
Heating suction temperature
shift
+6°C
HH > H+ > H >
L+ > L > LL