Continuous Drainage - Mitsubishi Electric MJ-E16SX-A1 Instruction Manual

Continuous Drainage

If a drain is available, the unit can continuously drain excess water by attaching a commercially available hose
(internal diameter 15mm).
The unit can be operated for extensive periods without the need to empty the water tank.
Do not drain water continuously
if there is a possibility that
temperatures around the hose could
drop below freezing point.
Water inside the hose may freeze and water may leak
from the unit and damage surrounding objects.
1
Remove the water tank.
Open the front door
2
Open the drainage outlet
Use cutters to cut the three fixing ribs of the
continuous drainage port on the back of the main
unit, then remove it carefully making sure that it
does not fall inside the unit.
3
Press drain stopper.
∞ Leave a minimum space of 20 cm behind the
unit for attaching the hose.
∞ Confirm that the hose does not show signs of
deterioration such as cracks and clogging.
∞ Inspect the hose every 2 weeks.
Insects or dirt blocking the hose may cause
leakage resulting in malfunctions.
18
Grasp handle and
pull out
Drain
Stopper
Push here
CAUTION
When draining water continuously or
left unattended for long periods,
inspect the unit once a fortnight.
Foreign objects, etc. could clog the hose
resulting in overheating and/or leakage.
4
Insert the hose into the drainage
outlet on the back
Hose
5
Replace the tank.
The unit cannot operate without returning the tank.
How to set up the drainage hose
Feed the
commercially
available hose (ID 15
mm) into the drainage
outlet while keeping
the stopper pressed
Confirm that the hose is
securely attached and
does not leak.
¡ hose immersed
in water
¡ hose raised to
a level higher
than the
drainage outlet