Installing The Sunshield - Bosch EX65 Instruction Manual

EX65 Explosion-protected Camera
5.
6.
7.
8.
7.2

Installing the Sunshield

1.
2.
3.
Bosch Security Systems, Inc.
Slightly loosen the six M6 bolts on both sides of the mounting cradle, using a 10mm
wrench or the supplied multi-use tool, and make directional adjustments to the EX65 so
that it is pointing at the desired surveillance target (see the graphics below).
Tighten all mounting bolts to 3 to 5 ft-lb (4.1 to 6.8 N·m).
Connect wiring as explained in Section 5 Connections, page 17, and follow all local
regulations and laws regarding explosion protected devices.
Connect the ground cable, located on the bottom of the housing, to a suitable grounded
material (grounded conduit or a ground wire).
Line up the mounting holes of the sunshield with the tapped holes in the body of the
EX65.
Install the supplied M4 bolts through the sunshield bolt holes into the body of the unit
and tighten by hand.
Tighten the supplied bolts to 1.5 ft/lb (2.0 N/m) using a 7 mm wrench or the supplied
multi-use tool.
Instruction Manual
Mounting | en 23
F.01U.412.061 | 2.0 | 2011.08