Bosch EX65 Instruction Manual page 21

EX65 Explosion-protected Camera
5.
6.
7.
8.
9.
10. Slide the inner mounting bracket assembly back into the camera housing and ensure that
11. Using a 10 mm wrench, tighten the three (3) bolts to secure the inner mounting bracket
12. Make sure that the o-ring and threads are clean and greased before replacing the front
13. Tighten the set screw on the front end cap using the supplied hex key.
Bosch Security Systems, Inc.
b. Pull the assembly out of the housing.
Figure 6.1 Camera pulled from housing
1 Inner mounting bracket assembly
2 Dinion 2X camera
3 Dinion menu buttons
Loosen the lens set screws for focus/zoom adjustments.
Use the set screw marked N <— —> ∞ to adjust image focus.
– Turn the set screw to the left to focus toward (N) (near) (zoom in).
– Turn the set screw to the right to focus toward (F) (far) / infinite (∞) (zoom out).
Use the set screw marked T <— —> W to adjust the telephoto or wide-angle settings.
– Turn the set screw to the left for a telephoto (tight) focal length
– Turn the set screw to the right for a wider focal length.
Re-tighten the lens set screws after focus adjustments have been completed.
To make adjustments using the Dinion 2X Main menu for a more detailed setup, refer to
Section 8 Operation, page 24.
it locks into place at the back of the housing. The bracket should not rotate and the
camera should be completely level.
assembly.
end cap. Use the supplied multi-use tool to tighten the rear end cap. Ensure that the O-
ring is properly seated. After tightening, ensure that there is no gap between the cap and
the body of the housing.
Instruction Manual
Configuration | en 21
F.01U.412.061 | 2.0 | 2011.08