Menu Navigation Keys; Pre-Defined Modes; Camera Control Communication (Bilinx) - Bosch EX65 Instruction Manual

EX65 Explosion-protected Camera
8.1.2

Menu navigation keys

Five keys are used for navigating through the menu system.
–
–
–
–
Some menus automatically close after about two minutes; other menus must be closed
manually.
8.2

Pre-defined modes

There are six pre-defined modes with settings to make configuration easier. You can select
one of the six modes in the Install/Mode submenu. The modes are defined as follows:
1.
2.
3.
4.
5.
6.
8.3

Camera control communication (Bilinx)

This camera is equipped with a coaxial communications transceiver (also referred to as
Bilinx). In combination with VP-CFGSFT, the camera setting can be changed from any point
along the coaxial cable. All menus can be accessed remotely giving full control of the camera.
With this method of communication it is also possible to disable the local keys on the camera.
To avoid loss of communication on an installed camera, the Communication On/Off selection
is not available while using remote control. This function can only be accessed with the
camera buttons. Bilinx communications can only be disabled using the buttons on the camera.
Disabled camera buttons
When the Bilinx communications link is active, the buttons on the camera are disabled.
Bosch Security Systems, Inc.
Use the up or down keys to scroll through a menu.
Use the left or right keys to move through options or to set parameters.
When in a menu, quickly double-press the menu/select key to restore the selected item
to its factory default.
To close all menus at once, hold down the menu/select key until the menu display
disappears or continually select the Exit item.
24-hour
Default installation mode to provide stable pictures over a 24-hour period. These settings
are optimized for out-of-the-box installation.
Traffic
Capture high-speed objects using default shutter in variable lighting conditions.
Low light
Provide extra enhancement, such as AGC and SensUp to make usable pictures in low-
light conditions.
Smart BLC
Settings optimized to capture details in high contrast and extremely bright-dark
conditions.
Low noise
Enhancements are set to reduce picture noise. Useful for conditional refresh DVR and IP
storage systems because reducing noise reduces the amount of storage required.
Analog systems
Use this mode if the camera is connected to a purely analog system (for example, matrix
switcher with VCR) or to a CRT monitor. Useful mode for evaluating/demonstrating the
camera when it is directly connected to a CRT monitor.
Instruction Manual
Operation | en 25
F.01U.412.061 | 2.0 | 2011.08