Physical Installation - Planet Networking & Communication ICA-HM230 User Manual

2.3.3 Physical Installation

1. Connect an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
NOTE: If there has an IEEE802.3af PoE switch in your network, you can connect the
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when Internet camera is connected to a PoE switch.
2. Check the LED (Front Panel)
The LED is defined to identify LAN connection type. When LAN port is connected, the LED
will be green.
3. Place the camera on the table or fix it onto ceiling or wall
Use screws to fix the Internet camera onto the ceiling or wall. You could also put the camera
in the table directly.
4. Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start to
operate.
NOTE: 1. Only use the power adapter supplied with Internet camera. Otherwise, the
product may be damaged.
2. The power adapter is unnecessary when Internet camera is connected to a
PoE switch. Otherwise, the product may be damaged when Internet camera is
connected to a PoE switch and power adapter simultaneously.
5. Attach Speaker to camera (option)
If user needs not only video stream but also audio stream, then the speaker should be
attached to camera.
13