Appendix A: Reset Factory Default Settings - Planet Networking & Communication ICA-HM230 User Manual

H.264 mega-pixel cmos pt internet camera

Table of Contents

Appendix A:

Reset Factory Default Settings

There is a button hidden in the pinhole near to the RJ-45 connector. This button is used to restore

the all factory default settings. Sometimes restarting the device will make the system back to a

normal state. However, if the system still got problems after restart, user can restore the factory

default settings and install it again.

Restore the device:

1. Insert the paper clip or other suitable tool to press and hold the button down continuously.

2. Hold it least 3 seconds and release the tool. Then the device has been restored to default

settings and reboot again.

Restoring the factory default setting will lose the all previous settings included IP

NOTE:

address forever. User needs to run the PLANET IPWizard II program to search the

device and configure it to let the device work properly again.

Factory Default

Reset Button

Table of Contents