Zte ZXR10 8900 Series Hardware Manual page 73

Interface Type
1000Base-T (RJ45)
10GBase-SR/SW-XFP
10GBase-LR/LW-XFP
10GBase-ER/EW-XFP
24 gigabit electrical interfaces on RS-89S2-24GE2XGE-RJ4SFPXFP
LEDs
card correspond to 24 indicators respectively, labelled from 1 to
24. 4 gigabit optical interfaces correspond to 4 indicators respec-
tively, labelled from 21 to 24. Their functions are shown in
72. There are also 2 10G optical interface, with each interface cor-
responding to two indicators. Their functions are shown in
73.
T 72 RS-89S2-24GE2XGE-RJ4SFPXFP C
ABLE
I LED F
NTERFACE
LED Type
LINK/ACT
Confidential and Proprietary Information of ZTE CORPORATION
Characteristics
RJ45 connector, Supporting
CAT5, 10/100/1000BASE-TX rate
adaptive, MDX/MDIX adaptive
and full duplex mode/half duplex
mode adaptive; the maximum
transmission distance is 150m
LC connector, 50 or 62.5 125mm
multi-mode fiber, with the
wavelength of 850nm,
As for 62.5um MMF
w/160MHz*km, the maximum
transmission distance is 26M.
As for 50um MMF w/ 500MHz*km,
the maximum transmission
distance is 82M.
As for 50um MMF w/
2000MHz*km, the maximum
transmission distance is 300M.
LC connector, 9/125mm
single-mode fiber, with the
central wavelength of 1310nm,
maximum transmission distance
is 10KM.
LC connector, 9/125mm
single-mode fiber, with the
central wavelength of 1550nm,
maximum transmission distance
is 40KM.
D
UNCTION ESCRIPTION
State Description
On: port link is created
Off: the port is disconnected from
others
Flash: data transmission and
reception on the port
Chapter 4 Hardware Board
Table
Table
G O
ARD IGABIT PTICAL
65