Transferring Ftp File To Ftp Server - Multitech MultiConnect Cell User Manual

CONFIGURING AND COMMUNICATING WITH YOUR DEVICE
SRING: 1
7. Accept incoming connection ID 1
Enter:
AT#SA=1
The device indicates a client successfully established a listener connection.
CONNECT
You can send and receive data.
Exit Data Mode and Close Connection
To exit data mode and close the socket:
■
Enter the escape sequence: +++
■
To close Socket 1, enter: AT#SH=1
The device responds with OK.
■ To close the data connection, enter:AT#SGACT=1,0
The device responds with OK.

Transferring FTP File to FTP Server

To connect to FTP server and upload files:
1. Check signal strength.
Enter:
AT+CSQ
2. Activate context one
Enter:
AT#SGACT=1,1
3. Set FTP operations timeout to 10 seconds
Enter:
AT#FTPTO=1000
4. Configure FTP server IP address with username and password.
Enter:
AT#FTPOPEN="###.##.###.#","username","password",0 where ###.##.###.# is the IP address and the
username and password for the FTP server.
5. Configure file transfer type.
Enter:
AT#FTPTYPE=# where # is 0 for binary or 1 for ASCII.
6. Enter the file name to be sent to the FTP server and initiate connection.
Enter:
AT#FTPPUT="file.txt"
The device responds with:
CONNECT
7. Send the file through the device.
30
®
MultiConnect Cell User Guide