KitchenAid DESIGNER COMMERCIAL-STYLE ISLAND-MOUNT CANOPY HOOD Installation Instructions And Use & Care Manual page 10

Dual Blower Motor Assembly
A. Wiring connection
2. Slide the left mounting plate flange under the motor mounting
bracket.
A B
A. Motor mounting bracket
B. Mounting plate left flange
3. Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
A. Motor mounting plate hole
B. Power supply wires and connector
10
4. Push the right end of the motor mounting plate up and snap it
into the spring tab.
A
NOTE: The spring tab should be outside the slot in the
mounting plate.
5. Align mounting holes in motor mounting plate with motor
mounting clip nuts and install 6 x 16 mm screws and 6.4 mm
lock washers (quantity 2 for single motor; quantity 5 for dual
motor).
A
6. Attach power supply connector from the range hood to the
connector on the blower motor assembly wiring box.
B
7. Go to the "Make Electric Power Supply Connection to Range
Hood" section.
A. Motor mounting plate
B. Spring clip
C
B
A
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut (6 mm)
A
B
A. Wiring box connector
B. Power supply connector from range hood
A
B