KitchenAid DESIGNER COMMERCIAL-STYLE ISLAND-MOUNT CANOPY HOOD Installation Instructions And Use & Care Manual page 8

36" (91.4 cm) and 48" (121.9 cm) designer commercial-style island mount canopy hood
Table of Contents

Advertisement

Available languages

Available languages

2. Install the transition piece using 3 - 4.2 x 8 mm mounting
screws to the range hood canopy.
3. Install the lower support bracket removed in Step 1 using the
10 - 4.2 x 8 mm mounting screws to the range hood canopy.
C
B
A
B
A. Lower support bracket
B. 4.2 x 8 mm mounting screws
C. Transition piece
4. Position the 4 vertical supports (A) with the notches at the
bottom and attach to the range hood using 16 - 4.2 x 8 mm
screws.
5. Attach the horizontal support (B) to the vertical supports (A) in
either the first or third set of holes from the top of the vertical
supports.
B
A
A
C
C
A. Vertical supports
B. Horizontal support
C. Notched end
6. Attach a second set of vertical supports (A) and set the
vertical height (B). See “Installation Clearances” in the
“Location Requirements” section to help determine the
desired dimension for vertical height “B.”
A
A
B
A. Vertical supports
B. Vertical height
7. Attach the range hood assembly to the upper horizontal
support attached to the ceiling using 16 - 4.2 x 8 mm screws
and tighten.
A
A. Mounting screws
8. Install the 4 supports using 8 - 4.2 x 8 mm screws.
NOTE: The notch in the supports (B) must be to the external
side when mounted.
9. Attach the vertical duct cover supports using 4 - 4.2 x 8 mm
screws.
A
B
C
D
A. Notch in support
B. Support
C. 4.2 x 8 mm screws
D. Vertical duct cover support
Connect Vent System
1. Install vent system.
2. Push duct over the exhaust outlet. Seal all connections with
vent clamps.
Page 8

Advertisement

Table of Contents
loading

This manual is also suitable for:

36" (91.4 cm) and 48" (121.9 cm)

Table of Contents