Turning The Heater On - Mitsubishi Electric Jet Towel JT-MC106G-W-NA Installation Manual

Initial setting checks - Continuation

Turning the heater on

1
Open the front cover.
2
Press the heater switch or the maintenance
switch and let the settings light turn on.
3
Turn the heater switch "ON".
The heater may not operate during continued use as there is
the danger of scalding when the temperature of the warm air
rises.
The air may not feel warm when the room temperature is low
(68 F (20 C) or below).
Checking the settings
The heater light and maintenance light turn off after about
10 seconds after their settings are made (to save energy).
To check the settings, press either the heater or maintenance
switch.
Settings and drying times guide
Drying times guide
(approx.) 13 seconds
Drying times are based on Mitsubishi measurements. (50mg of water per hand)
Noise
(approx.) 64dB
NA 14
Open
Front cover
Heater switch
Heater
light
Heater
switch