EFI Splash RPX-ii Troubleshooting Manual page 13

T
ROUBLESHOOTING
Restarting the Fiery
After you set the IP address, the Fiery automatically reboots and prints a Start Page.
Check that the IP address on the Fiery Start Page is correct. If it is not, go back to the copier
and reset the IP address.
T F
O RESTART THE IERY MANUALLY
1 Turn off the copier.
2 Wait one minute, and then turn on the copier.
You may have to wait a few minutes for the Fiery to restart and print the Start Page and for
the Splash RPX-ii to detect the Fiery. The Splash RPX-ii will not complete the connection
until the Fiery Start Page prints.
Once the connection is successful, the Splash RPX-ii Startup Page prints.
13