EFI Splash RPX-ii Troubleshooting Manual page 12

T
ROUBLESHOOTING
N : You may have to manually restart the Fiery (see
OTE
• Verify that the IP address on the Start Page is correct.
• Start the Splash RPX-ii.
Setting the IP address
Set the copier to a fixed IP address using the following procedure.
T IP
O CONFIGURE THE COPIER
1 Power on or wake up the copier.
2 Press the Log In/Out button on the copier.
3 Type the ID using the keypad, and then press Confirm on the copier touch panel.
N : The ID is usually "11111".
OTE
4 Press System Settings > System Settings > Network Controller Settings > Network Settings on
the copier touch panel.
5 Press 2 TCP/IP - Get IP Address and press Change Settings.
6 Press Manual and press Save.
7 Press 3 TCP/IP - IP Address and press Change Settings.
8 Type the IP address using the keypad.
If the Fiery is running version 2.0 or later software, enter
If the Fiery is running version 1.1 software, enter:
• 169.254.208.164
• otherwise
192.168.0.1
N : If the IP address is correct, no update occurs. In this case, reboot the Fiery manually.
OTE
For more information, see
9 Press 4 TCP/IP - Subnet Mask and press Change Settings.
10 Type 255.255.0.0 using the keypad and press Save.
11 Continue to press Close on the copier touch panel to close the Settings panels.
12 Press Exit.
ADDRESS USING THE COPIER TOUCH PANEL
if your network uses addresses in the range 192.168.x.x.
"To restart the Fiery manually"
page 13).
169.254.208.164 .
on page 13.
12