Advertisement
6.
Once the Internet Connection feature is activated per step 4 above, you may now
press the [%] key, while you are transmitting, to send out the selected DTMF
string (to establish the link to the desired Internet-link mode).
7.
To return to the WIRES
4.
CW Training Feature
The FT-2900r provides a CW Training feature, which sends random Morse Code via the
sidetone (heard in the speaker), so you can improve your CW proficiency.
1.
Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to
select "12 CWTRNG."
2.
Press the [MHz(SET)] key momentarily to enable adjustment of this Set Mode
Item.
3.
Press the [LOW(A/N)] key to select the Training mode (displayed in fine print at
the upper edge of the LCD):
1A:
Sends five Alphabet characters only
A:
Sends Alphabet characters only (Repeatedly)
1n:
Sends five Numeric characters only
n:
Sends Numeric characters only (Repeatedly)
1An: Sends five Alphabet, Numeric, "?," and "/" characters (Mixed)
An:
Send Alphabet, Numeric, "?," and "/" characters (Mixed, Continuously in
group of five)
4.
Rotate the DIAL knob to select the Morse speed. You may select the units of the
code speed between "WPM (Words per minute)" and "CPM: characters per minute)"
by pressing the [D/MR(MW)] key.
5.
Press the [REV(DW)] key to begin generation of the code characters (CW sidetone
only, the radio does not transmit); the transmitted characters will appear on the
display. If one of the "1" modes is selected in step 4 above, press the [F/W] key to
send another code group.
6.
To disable the CW Training feature, press the [MHz(SET)] key momentarily.
7.
Press and hold in the [MHz(SET)] key for one second to exit to normal operation.
R.F. Says: The "WPM" selection is based on the international "PARIS" standard, which
stipulates five characters per word.
mode, repeat steps 1 - 3 above, selecting "SRG" in step
TM
40
FCC ID:K6620393X50
IC: 511B-20393X50
Operating Manual
Advertisement
