Download Print this page

Yaesu FT-2900R Operating Manual page 28

Hide thumbs Also See for FT-2900R:

Advertisement

[D/MR(MW)] key for one second, rotate the DIAL to select the masked memory's
number, then press the [LOW(A/N)] key to restore the memory channel's data.
R.F. Says: Watch out! You can manually store data over a "Masked" memory, deleting
previous data, if you're not careful. Use the "next available memory" technique (look for
the blinking memory channel number) storage technique to avoid over-writing a
masked memory.
Memory Bank Operation
The large number of memories available in the FT-2900R could be difficult to utilize
without some means of organizing them. Fortunately, the FT-2900R includes provision
for dividing the memories into as many as eight Memory Banks, so you can categorize
the memories in a manner convenient to you. You may enter and exit the "Memory
Bank" mode by a single press of the Microphone's [#] key, as we shall see below.
Assigning Memories to a Memory Bank
1.
Recall the memory channel to be assigned to a Memory Bank.
2.
Press and hold in the [D/MR(MW)] key for one second, then rotate the DIAL knob
to select the Memory Bank number ("b1" ~ "b8") you want as the Memory Bank for
this channel.
3.
Press the [D/MR(MW)] key momentarily to copy the memory channel data into the
Memory Bank.
R.F. Says: 1) You may assign one memory channel into several Memory Banks.
2) The PMS memory channels (L0/U0 through L9/U9) may not be assigned to a
Memory Bank.
Memory Bank Recall
1.
Press the [D/MR(MW)] key, if needed, to enter the Memory mode.
2.
Press the Microphone's [*] key to activate the "Memory Bank" mode. The Memory
Bank number will appear on the display.
3.
Press the [#] key to increment the Memory Bank ("b1" through "b8").
4.
Rotate the DIAL knob to select memories, you will observe that you can only select
memory channels in the current memory bank. The small memory bank number
will appear at the above of the frequency display while operating within a Memory
Bank.
5.
To change to another Memory Bank, press the [#] key to increase the Memory
Bank to next-highest bank.
6.
To exit from Memory Bank operation, just press the Microphone's [*] key. The
28
FCC ID:K6620393X50
IC: 511B-20393X50
Operating Manual

Advertisement

loading