Advertisement
PTT:
The PTT switch is locked (TX not possible)
K+P:
Both keys and PTT switch are locked out
D+P:
Both DIAL knob and PTT switch are locked out
ALL:
All of the above are locked out
OFF:
The Lock feature is disabled
To lock out some or all of the keys, use the "Set" (Menu) mode, described in detail
beginning on page 51:
1.
Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to
select "26 LOCK."
2.
Press the [MHz(SET)] key, then rotate the DIAL knob to set the display to one of
the selections shown above.
3.
Press and hold in the [MHz(SET)] key for one second to save your new setting and
exit to normal operation.
When the Lock feature is activated, the "KEY" icon will appear on the LCD.
To disable the Lock feature, repeat the above process, selecting "OFF" in step 2 above.
Keypad Beeper
A key/button beeper provides useful audible feedback whenever a key/button is pressed.
If you want to turn the beeper off (or back on again):
1.
Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to
select "6 BEEP."
2.
Press the [MHz(SET)] key, then rotate the DIAL knob to set the display to "OFF.
3.
Press and hold in the [MHz(SET)] key for one second to save your new setting and
exit to normal operation.
Channel Step Selection
Tuning steps are factory preset to default increments which are appropriate for the
country to which this radio is exported. You may have a reason to use a different step
size, however, and here is the procedure for changing the channel steps:
1.
Press and hold in the [MHz(SET)] key for one second, then rotate the DIAL knob to
select "50 STEP."
2.
Press the [MHz(SET)] key, then rotate the DIAL knob to select the desired step
size (5/10/12.5/15/20/25/50/100 kHz).
3.
Press and hold in the [MHz(SET)] key for one second to save your new setting and
exit to normal operation.
14
FCC ID:K6620393X50
IC: 511B-20393X50
Operating Manual
Advertisement
