Owner's Manual Permobil K300/C300/C300s
Changing inner tube
NOTE!
Applies only if your wheelchair is fitted with pneumatic
rear tires.
1. Switch off the main power switch on the control panel
2. Chock up the wheelchair so that the wheel turns
freely and let out the air.
3. Remove the wheel, it´s fitted with four screws.
4. Release the air.
5. remove the six screws holding the rim together.
6. Take the rim apart.
7. Replace the inner tube (2) in the tire (3) and fit togeth-
er with the two rim halves (1&4). Tighten the six
screws using a dynamometric wrench. Tightening
torque: 24 Nm.
8. Fill the tire to recommended tire pressure, 200 kpa (2
bar).
9. Fit the wheel on to the wheelchair. Tighten the four
screws using a dynamometric wrench. Tightening
torque: 24 Nm.
120
Figure 101. Changing inner tube.
Maintenance and repairs