Audiovox AS-9234 Owner's Manual page 10

In many cases, to increase the security of your system, you may elect to
change the manual override code to a number that is more familiar to you, or
simply to have a different code than was pre-assigned from the factory.
To change the pre-assigned override code follow the steps outlined below.
It is advised you read both sections under the headings "Programming Your
Custom Override Code" and, "Custom Code Programming Example", to com-
pletely understand the procedure before you begin:
CUSTOM CODE OVERRIDE EXAMPLE:
To change the code from the factory pre-assigned code of 11 to "52" you
would do the following:
1. Disarm the system by use of the transmitter, or by use of the emergency
override sequence.
2. Turn the ignition switch to the on position.
3. Within 10 seconds, press and release the PRLED, or the optional
push-button switch found on the glass mounted receiver assembly 3 times.
4. Within 10 seconds turn the ignition switch off, on, off, on, off, on.
(The siren or horn will beep and the lights will flash one time.)
5. Within 10 seconds, begin to press and release the PRLED, or the
optional push-button switch found on the glass mounted receiver
assembly to set the tenths digit.
(As per the example, press 5 times to set the tenths digit to 5)
6. Within 10 seconds of the last press of the push-button, turn the ignition
` switch off then on.
7. Within 10 seconds, begin to press and release the PRLED, or the
optional push-button switch found on the glass mounted receiver
assembly to set the units digit.
(As per the example, press 2 times to set the units digit to 2).
8. Turn the ignition switch to the off position. Immediately observe the
LED flash pattern.
Page 10
128-8970a
10 of 20