Appliance Preparation; Top Vent - Heat & Glo SOHO-B-CEB Owner's Manual

9
Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
ELBOW HEAT SHIELD
Figure 9.1
An elbow heat shield is attached to the SOHO-CEB. Do
not remove this heat shield.
SUPPORT TAB
Figure 9.2
If venting with a 90 degree elbow directly off of the top of
the unit, the heat shield should be placed as shown. Ro-
tate the heat shield up to the vertical position and fold the
tab down to contact the elbow. Make sure the rope ring,
found in the manual bag, is in place around the elbow
before attaching more pipe.
34
ROPE RING
Heat & Glo • SOHO-B-CEB, SOHO-N-CEB, SOHO-P-CEB • 2111-980 Rev. i • 3/13
Figure 9.3
This is a view from the front of the unit when the elbow
heat shield is properly in place.
Figure 9.4
If venting vertically or using vertical pipe before the elbow,
rotate the elbow heat shield to a vertical position and fold
the heat shield in half as shown. Make sure the rope ring,
found in the manual bag, is in place around the first sec-
tion of vent pipe.
Figure 9.5
This is a view from the front of the unit when not using an
90 degree elbow directly off the top of the unit.
ROPE RING