Adding Pci Cards - Supero SUPERSERVER 2026T-URF4+ User Manual

S S
UPER ERVER 2026T-URF4+ User's Manual
5-6

Adding PCI Cards

PCI Expansion Slots
The X8DTU-LN4F+ has one Universal PCI slot. Riser cards installed to the system
allow you to add PCI expansion cards (see below). The SC219TQ-R920UBP chas-
sis can support the use of one PCI-E 2.0 x8, two PCI-E 2.0 x4 add-on cards and a
UIO slot on the left side and two PCI-E 2.0 x4 add-on cards on the right side (with
pre-installed riser cards).
PCI Card Installation
Before installing a PCI add-on card, make sure you power off the system fi rst. Begin
by removing the top chassis cover. Two riser cards should be pre-installed into the
system. Remove the screws that secure the riser cards to the rear of the chassis
then lift the riser card assembly from the chassis. Insert the PCI card into the riser
card slot, pushing down with your thumbs evenly on both sides of the card - note
that the add-on card attaches to the riser card with a single screw. After the card
has been installed, reinsert the riser card back into the expansion slot on the board,
then secure it with the same screws you removed previously. Finish by replacing
the chassis cover.
5-12