Scanner Unit/Hinge - Epson Stylus CX7300 Service Manual

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C

4.3.4 Scanner Unit/Hinge

Parts/Components need to be removed in advance
Document Cover/ASF Cover
Removal procedure
1. Remove the screw (x1) that secures the USB Cover.
2. Pull the USB Cover at its screwing part, and remove it by sliding it to the left
(in the direction of the arrow).
Back Side
Rear Left
Screwing Part
Figure 4-6. Removing the USB Cover
DISASSEMBLY/ASSEMBLY
USB Cover
USB Cover
C.B.S. 3x8, F/Zn-3C (6±1kgfcm)
Tab
Rib
Be careful of the sharp edges shown in
C A U T I O N
assembling or reassembling.
3. Disconnect the Scanner Motor Cable from the connector (CN10) and the
Scanner Carriage FFC from the connector (CN21) on the Main Board.
4. Peel off the double-sided tape (x1) that secures the Scanner Carriage FFC to
the Main Board Frame.
5. Peel off the double-sided tape (x1) that secures the Scanner Carriage FFC to
the Upper Housing.
Upper Housing's inside
Double-sided Tape
Scanner Motor
Cable
Removing the Housing
Upper Housing
Scanner Carriage FFC
Scanner Carriage FFC
Main Board Frame
Figure 4-7. Removing the Scanner Unit (1)
Figure 4-7 when
Double-sided Tape
CN21
CN10
Sharp Edge
98
Confidential