Front Panel Connectors - DFI CR100-CRM User Manual

Front Panel Connectors

HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1
(POS - Power On Suspend) state, it will blink every second. When the system is
in the S3 (STR - Suspend To RAM) state, it will blink every 4 seconds.
Pin
HDD-LED 3
5
RESET SW 7
9
11
Pin Assignment
HDD Power PWR-LED
Signal
Ground
RST Signal PWR-BTN
N.C.
Hardware Installation
1 2
HDD-LED
RESET-SW
11
12
Pin Pin Assignment
2 LED Power
4 LED Power
6 Signal
8 Ground
10 Signal
2
PWR-LED
PWR-BTN
51