General Assembly Instructions - Vacmaster VJC1210PF Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

A Philips head screw driver is required.
WARNING
: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as listed on page 5.
(fig. 4)
5. Turn the container upside down and insert the four caster feet into the slots on the container and tighten
with supplied screws. Verify that the casters are mounted correctly. Do not over-tighten screw. (fig. 5)
6. Your vacuum comes ready for dry vacuum cleaning. If cartridge filter is not installed refer to page 10 for
filter installation. (fig. 6 & 7）
7. For wet vacuum cleaning, install the supplied foam filter. (fig. 8) See page 10 for filter installation.
8. Place the power head back on the container, aligning the top section with the latches, and snap into
place. (fig. 9)
9. Insert the locking end of the hose into the port of the container and lock in to place. (fig. 10)
10. Choose the desired accessories and push onto the suction tube. (fig. 11)
NOISE DIFFUSER
For quiet operation, install the noise diffuser into the blower port by inserting the locking end
of the diffuser into the blower port and turning clockwise to lock into place.
6