Display Check After Changing The Setting - Epson PhotoPC3100Z Service Manual

PhotoPC 3100Z

1.10.2 Display check after changing the setting

The described number at the right of "Version :" in the following examples of display
is the description of firmware.
AT THE END OF THE CHANGE PROCESS A
Confirm that the "NTSC / TWN" is indicated at the lower left of screen, then push
POWER button to turn the power off.
Figure 1-16. Display at the end of change process A
PRODUCT DESCRIPTION
AT THE END OF THE CHANGE PROCESS B
Confirm that the "PAL / SEL" is indicated at the lower left of screen.
Only at the change of setting into the "PAL / SEL", the display will automatically
changed into the below example a few seconds after changing. When confirming the
indication of the "PAL / SEL", push POWER button to turn the power off at the
following display.
Figure 1-17. Display 1 at the end of change process B
Other than the change of setting into the "PAL / SEL", the display would not be
changed into the following example. Therefore, when the following display was
shown, you can judge that the change of setting into the "PAL / SEL" was properly
done.
Figure 1-18. Display 2 at the end of change process B
Ex-factory Setting
Revision A
35