Preparation For Adjustment - Epson PhotoPC3100Z Service Manual

PhotoPC 3100Z

5.3 Preparation for Adjustment

This section describes how to set up the camera and PC before adjustment. Follow the
procedures below and complete setting up. Prepare PC with Windows2000 Me,
Windows2000 Professional or later. (See the caution below.)
W A R N I N G
Remove the battery and plug off the AC adapter before
disassembling the camera.
The electrolytic capacitor (C5412) mounted on PW1 board is
for flash strobe and set to be charged automatically whenever
the power is ON. Due to this, it may cause electric shock
during the service procedure. When repairing, be sure to
discharge the camera, using the cement resistance. (See Refer
to Figure 4-1..)
C A U T I O N Host computer should meet the following specifications.
PC/AT compatible PC with more than Pentium CPU
FD drive for 3.5 inch 2HD
PC with the USB port
RAM: 40MB or more
HDD drive: 15 MB or more
VGA or AVGA monitor with at least 256-color display.
If you try to boot the program with the camera off, the
program indicates "Camera is not connected." and
becomes error condition.
Adjustment
1. Connect a USB cable to the camera and turn on the camera.
2. Lining up the arrow on the cable connector with the notch on the camera's serial
port, insert the connector.
3. Connect the USB cable to the USB port of PC.
NOTE: Since the PC automatically recognizes the camera connected to the USB
port, it is not necessary to reboot the PC.
4. Insert the attached FD which has the adjustment program into your PC.
5. Double-click "DSCCalDi.EXE" to start the program automatically.
Preparation for Adjustment
To USB port
USB cable
Figure 5-1. Set-up Before Adjustment
Revision B
AC adaptor
80