Ex-Factory Setting; Change Process Of Camera Setting - Epson PhotoPC3100Z Service Manual

PhotoPC 3100Z

1.10 Ex-factory Setting

With a special setting mode, the setting of camera is changeable depending on the
destination as well as PhotoPC 3000Z. The setting is the same as that for PhotoPC
3000Z.

1.10.1 Change process of camera setting

Proceed the setting for the following destinations.
(The default setting for the foreign country models is: language=English,
Video=NTSC)
Destination
ETT B 1 4 4 0 2 1 -
EDG/EFS/EIS/EIB B 1 4 4 0 3 1 -
EUL B 1 4 4 0 3 2 -
EUL (Nordic) B 1 4 4 0 3 3 -
EAL B 1 4 4 0 3 6 -
EHK B 1 4 4 0 3 5 -
ESP B 1 4 4 0 3 7 -
NOTE: variable factors depending on the product revision and the timing of ex-
factory.
Check the followings before the change of destination.
Set the dial switch at the "SETup" position.
Remove the CompactFlash (CF) card from the camera.
CHANGE PROCESS A : CHANGE INTO THE NTSC / ENG SETTING
WITHOUT CHINESE INDICATION.
1. Push POWER button (the center of dial button) to turn the power on while pushing
(Flash) button.
2. Confirm that the "NTSC / TWN" is indicated at the lower left of screen, then push
POWER button again to turn the power off.
PRODUCT DESCRIPTION
Table 1-15.
Change process
∗∗∗∗
1
*
Change process A
∗∗∗∗
1
*
Change process B
∗∗∗∗
1
*
Change process B
∗∗∗∗
1
*
Change process B
∗∗∗∗
1
*
Change process B
∗∗∗∗
1
*
Change process B
∗∗∗∗
1
*
Change process B
CHANGE PROCESS B : CHANGE INTO THE PAL / NO LANGUAGE
Start from the language selection menu at the initial power on process.
1. Push POWER button (the center of dial button) to turn the power on while pushing
(Self timer) button.
2. Confirm that the "PAL / SEL" is indicated at the lower left of screen, then push
POWER button again to turn the power off.
NOTE: If the display is switched into the language / video selection mode screen
after proceeding the change process B, turn the power off without
pushing the "BACK".
RETURN TO THE EX-FACTORY DEFAULT SETTING
In case of failure in changing the setting, it would be necessary to return to the ex-
factory default setting. Push POWER button (the center of dial button) to turn the
power on again while pushing
default setting.
Indication Destination
NTSC/JPN Japan
NTSC/ENG USA, Korea
NTSC
Taiwan
/ TWN
Other than above
PAL/SEL
countries
C H E C K
After setting, the setting condition is changed and some factors such as
P O I N T
date are initialized and reset.
Ex-factory Setting
SETTING.
(Image quality) button to return to the ex-factory
Table 1-16. Detail setting
VIDEO Language
NTSC Japanese Shutter button + Power on
NTSC English Resolution button + Power on
English
NTSC Flash button + Power on
(no Chinese)
Select Lang. screen Self timer button + Power on
Revision A
Procedure
34