Pre-Start Instructions - Chicago Electric 98838 Operation Instructions Manual

8. 12 Volt Dc Fuse (8):
Generator from overloading. The Generator is equipped with the following size
and type of Fuse: F10A250V. Should a 12 VDC output exceed the fuse's rating,
always check to see if the Fuse has "blown" (a melted filament within the Fuse). If
necessary, unplug all electrical loads from the Generator, replace with a new Fuse,
and reattach a reduced load to the generator. (See Figure c.)
9. Power-On Light (10):
(See Figure c.)
To Add Engine Oil:
1. cAuTiON! Your warranty is voided if you do not put engine oil in the Engine's
crankcase prior to its first use. Before each use, check the oil level. Never run the
Engine with low or no engine oil. Running the engine with low or no oil will perma-
nently damage the Engine.
FuEL GAuGE
(35)
FuEL TANK
(31)
2. The Engine MuST be filled with a high quality grade engine oil. If the Engine will
be run in temperatures above 32 degrees Fahrenheit, use SAE 30 weight oil. If
SKU 98838 For technical questions, please call 1-800-444-3353.
The 12 Volt DC Outlet has one Fuse (8) to protect the
Indicates voltage is being provided by the Generator.

PRE-START iNSTRucTiONS

OiL DiPSTicK
(65A)
FuEL FiLTER
(32)
FuEL TANK cAP
(34)
ThiS GENERATOR
hAS AN AuTO-
ShuTDOWN OiL
SENSOR. iF
ENGiNE STOPS OR
WiLL NOT START,
chEcK OiL LEVEL.
FiGuRE D
Page 13