Assembly Instructions - Chicago Electric 98839 Set Up, Operating, And Servicing Instructions

When unpacking, check to make sure all the parts shown on the Parts Lists on
pages 20 and 22 are included. If any parts are missing or broken, please call Harbor
Freight Tools at the number shown on the cover of this manual as soon as possible.
cAuTiON! Make sure Engine's Ignition (2) is in its "OFF" position prior to per-
forming any service, maintenance, or cleaning of Generator or Engine. Always
wear ANSI- approved safety impact eye goggles when assembling and using
the Generator.
To install The Battery (not included):
NOTE: For proper operation, you must install a Dc 12v, 18-35 Amp-hour Battery.
NEGATivE BATTERY cABLE
(64)
BATTERY
(45)
Not included
BATTERY BRAcKET
(47)
BOLT W/LOcK WAShER
(46)
1. Remove the packing from the Battery (45). Then, locate the factory pre-installed
Battery Guard Plate (44) and Battery Tray (48) beneath the Control Panel (4) of the
Generator unit. (See Figure A, previous page.)
2. Slide the Battery (45) into the Battery Guard Plate (44), with the Battery's terminals
facing outward and with the Battery's negative (–) terminal facing left.
(See Figure A.)
3. Align the two mounting holes in the Battery Bracket (46) with the two threaded mount-
ing holes in the Battery Guard Plate (44). Then secure the Battery Bracket to the
Battery Guard Plate, using two Bolts with Lock Washers (46). (See Figure A.)
SKU 98839 For technical questions, please call 1-800-444-3353.
uNPAcKiNG

ASSEMBLY iNSTRucTiONS

POSiTivE BATTERY cABLE
BATTERY GuARD PLATE (44)
(FAcTORY PRE-iNSTALLED)
BATTERY TRAY (48)
(FAcTORY PRE-iNSTALLED)
(63)
FiGuRE A
Page 9