Site Preparation, Electrical Requirements & Initial Setup - Bunn CDS-2 Operating & Service Manual

SITE PREPARATION
These dispensers are very heavy. Place them on a sturdy counter or shelf capable of supporting at least 180
lbs for the CDS2 and 250 lbs for the CDS3. They are for indoor use only.
The dispenser must have at least four inches of space behind it. This space is needed for airflow, air filter
removal, and cleaning. Minimal clearance is required between the dispenser sides and the wall or another
appliance. The dispenser performs better if not placed near any heating appliance. Leave some space so the
dispenser can be moved for cleaning.
ELECTRICAL REQUIREMENTS
CAUTION – Improper electrical installation will damage components. An electrician must provide electrical
service as specified below.
Model CDS-2, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch
circuit rated 120 volts ac, 15 amp, single phase, 60 Hz. The mating connector must be a NEMA 5-15R. (Refer
to the dataplate for exact electrical requirements.)
Model CDSA-2, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch
circuit rated 230 volts ac, 10 amp, single phase, 50 Hz. The mating connector must be a NEMA 5-15R. (Refer
to the dataplate for exact electrical requirements.)
Model CDS-3, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch
circuit rated 120 volts ac, 20 amp, single phase, 60 Hz. The mating connector must be a NEMA 5-20R. ( Refer
to the dataplate for exact electrical requirements.)
Model CDSA-3, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch
circuit rated 230 volts ac, 15 amp, single phase, 50 Hz. The mating connector must be a NEMA 5-20R. ( Refer
to the dataplate for exact electrical requirements.)
NOTE – Bunn-O-Matic does not recommend the use of any extension cord with these dispensers.
5
27646 122200