Lubrication - Bunn CDS-2 Operating & Service Manual

RECOMMENDED WEEKLY CLEANING (CONT.)
11. Wash all components with a wash cloth in mild hot water and detergent solution. Do not immerse hopper lids.
12. Wash the drums, hopper drip trays, top covers, and outer enclosure using a clean wash cloth that has been
dampened in a mild solution of detergent and hot water.
13. Thoroughly rinse all surfaces with a clean wash cloth that has been dampened with hot water. Wipe dry with
a clean dry wash cloth before reassembling the dispenser.
14. Remove the lower drip tray assembly. Wash and thoroughly rinse all pieces before reinstallation.
NOTE – Although most parts are dishwasher safe, they may be affected by some commercial sanitizing agents.
Do not place the hopper nor hopper lids in a dishwasher.

LUBRICATION

NOTE – Use BOM M2550.0000 lubricant where specified.
1. Squeeze some lubricant into
hand.
4. Press the seals firmly into
place.
7. Align the auger shafts with the
flat fin of the augers. Push the
augers as far as they will go and
rotate them so the flat fins are
pointing up.
2. Apply a thin film of lubricant to
each cooling drum seal.
5. Apply a thin film of lubricant to
the inside of each auger shaft
seal.
8. Thoroughly rinse the hoppers
and install them over the cool-
ing drums with augers. Slide
them into place and push them
down as far as they will go.
As much as possible, keep lu-
bricant from the inside of the
hoppers. The cleaner you keep
the food zone, the cleaner the
product you'll serve the cus-
tomer.
13
3. Install the seals over the flange
at the rear of the cooling drums
as shown.
6. Install the seals on the auger
shafts. Wipe the cooling drums
to remove any excess lubricant.
9. Set the lids on the hoppers.
27646 022500